The filament would nosecone, Nice work Curtis!
Wow that goes way up there
Release cloth makes for a smooth fillet
Rods to secure harness and transfer the load to the aft
Marking retainer bolt pattern
Making dimples so I can drill all those holes
Drilling holes for the retainer
Rods were made over sized so I can cut them to length
Trimming the rods to length
Top of rods, harness attachment (before being pulled in to rest on top of the CR)
That top fillet is way down there
Time for paint, installed the motor forward bulklhead into the aft of the motor to use the eyebolt to hang it
One of the two accelerometers I built for the flight